Data manipulation instructions Chapter 13
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 301
Parameter Parameter type Data type Description
Dest Input BOOL
SINT
USINT
BYTE
INT
UINT
WORD
DINT
UDINT
DWORD
REAL
TIME
DATE
STRING
LWORD
ULINT
LINT
Initial element to be overwritten by the source.
DestOffset Input UINT Destination element offset.
The element offset if the destination is an array data type.
Set the offset to 0 if:
• If it is not an array data type, or
• To copy from the first element for an array data type.
Length Input UINT Number of Destination Elements to copy.
When the destination is a String data type, it indicates the
number of strings to be copied.
Swap Input BOOL TRUE: Swap bytes according to the Data Type.
A swap operation will not occur if:
• The source data type or the destination data type is a String, or
• If both the source and the destination are 1-byte length data.
Sts Output UINT Status of the copy operation.
See COP operation status values on page 303
ENO Output BOOL Enable out.
Applies only to LD programs.
To Next Page
Loading...
