Allen-Bradley Micro800 - SYS_INFO Data Type

Input/Output instructions Chapter 15
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 415
SYS_INFO data type
The following table describes the SYSINFO data type.
Parameter Data type Description
BootMajRev UINT Boot Major Revision.
BootMinRev UINT Boot Minor Revision.
Operating System Series UINT Operating System Series:
0 indicates a series A device
1 indicates a series B device
OSMajRev UINT OS Major Revision.
OSMinRev UINT OS Minor Revision.
ModeBehaviour BOOL Mode Behavior (TRUE: Go to RUN on power up).
FaultOverride BOOL Fault Override (TRUE: Override error on power up).
StrtUpProtect BOOL Startup Protection (TRUE: Run startup protection program on power up).
Tip: For future release
MajErrHalted BOOL Major error halted (TRUE: Major error halted).
MajErrCode UINT Major error code.
MajErrUFR BOOL Major error during user fault routine.
Tip: For future release
UFRPouNum UINT User fault routine program number.
MMLoadAlways BOOL Memory Module restore to controller always on power up (TRUE: Restore).
MMLoadOnError BOOL Memory Module restore to controller if power up with error (TRUE: Restore).
MMPwdMismatch BOOL Memory Module password mismatch (TRUE: Controller and Memory Module password mismatch).
FreeRunClock UINT Free running clock that increments every 100 microseconds from 0 to 65535 and then returns to 0. You can use the
Clock, which is globally accessible, if you need more resolution than the standard 1 millisecond timer.
Tip: Only supported for Micro830 and Micro850 controllers. Value for Micro810 controllers remains 0.
ForcesInstall BOOL Forces enabled (TRUE: Enabled).
EMINFilterMod BOOL Embedded filter modified (TRUE: Modified).