High-Speed Counter (HSC) instructions Chapter 14
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 355
Example: Programmable Limit Switch (PLS) enabled
This topic describes the results when PLS is enabled using specific HSC and
PLSData parameter values.
HSC parameter values
This example assumes the following HSC parameters use these values.
• HSCApp.OutputMask = 31
• HSCApp.HSCMode = 0
• HSC controls Embedded Output 0...4 only
PLSData parameter values
This example assumes the PLSData parameters for the variable (HSC_PLS) are
configured as shown in the following figure.
To Next Page
Loading...
