Chapter 14 High-Speed Counter (HSC) instructions
354 Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
Results
In this example, the PLS variable has a dimension of [1..4]. This means that
the HSC can have four pairs of High and Low Presets.
• High Presets should always be set lower than the OFSetting and the
Low Preset should always be greater than the UFSetting.
• The HscHPOutPut and HscLPOutPut values will determine which
outputs will be turned on when a High Preset or Low Preset is reached.
To Next Page
Loading...
