Input/Output instructions Chapter 15
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 401
PLUGIN_WRITE writes a block of data to any Plug-in Generic Module
hardware except 2080-MEMBAK-RTC modules.
Arguments
Parameter Parameter type Data type Description
Enable Input BOOL Function block enable.
When Enable = TRUE, execute Plug-in write.
When Enable = FALSE, there is no data write operation.
SlotID Input UINT Plug-in slot number.
Slot ID = 1,2,3,4,5 (starting with the far left slot = 1).
Offset Input UINT Address offset of the first data to be written, calculating from the first byte of the
Plug-in Generic Module.
DataLength Input UINT The number of bytes to be written.
DataArray Input USINT Data to be written to the Plug-in Generic Module.
Sts Output UINT See PLUGIN_READ status codes on page 398.
ENO Output BOOL Enable out.
Applies only to LD programs.
To Next Page
Loading...
