Chapter 15 Input/Output instructions
392 Rockwell Automation Publication 2080-RM001D-EN-E - February 2015
For controllers using an SD card:
MMINFO data type
The following table describes the MMINFO data type parameters.
Parameter Data type Description
MMCatalog MMCATNUM The catalog number of the Memory Module.
Note: When using the MM_INFO instruction on controllers with an SD card, the
MMCatalog is "SD CARD".
Series UINT The series of the Memory Module.
Note: When using the MM_INFO instruction on controllers with an SD card, the series is
0.
Revision UINT The revision of the Memory Module.
Note: When using the MM_INFO on controllers with an SD card, the revision is 0.
UPValid BOOL User program valid (TRUE: Valid).
ModeBehavior BOOL Mode behavior (TRUE: Go to RUN on power up).
LoadAlways BOOL Memory Module restore to controller always on power up.
LoadOnError BOOL Memory Module restore to controller if power up with error.
FaultOverride BOOL Override fault on power up.
MMPresent BOOL Memory Module is present.
To Next Page
Loading...
