High-Speed Counter (HSC) instructions Chapter 14
Rockwell Automation Publication 2080-RM001D-EN-E - February 2015 329
LPOutput
Parameter Data type User program access
HSCApp.LPOutput UDINT read/write
LPOutput (HSCApp.LPOutput) defines the state (1 = "on", 0 = "off ") of the
outputs on the controller when the low preset is reached. For more information
on how to directly turn outputs on or off based on the low preset, see
OutputMask.
You can configure the low output bit pattern during initial setup, or you can use
the HSC function block to load the new parameters while the controller is
operating.
HSCSTSInfo parameters example
The following image shows the HSCStsInfo parameters in the Variable Selector.
To Next Page
Loading...
