104 Rockwell Automation Publication 6000-UM002E-EN-P - April 2018
Chapter 5 Preventative Maintenance and Component Replacement
Figure 36 - Lift Cart Procedure
Install Power Module
1. You can use the lift cart to move and position the Power Module to the
appropriate location in the cabinet.
2. Push the Power Module slowly along the guide rails until it cannot be
pushed in further.
Hand Crank
Foot Crank
Pressure Release Knob
1. Check the lift tray before use to ensure the tray
can be raised and lowered smoothly.
2. Rotate the Pressure Release Knob
counterclockwise to ensure that the tray is in
the lowest position.
3. Move the Power Module on the tray and lift
the module to the appropriate height using the
Foot Crank and complete the installation.
4. Rotate the Pressure Release Knob
counterclockwise to lower the tray to its
original position.
5. Repeat steps 1...4 to complete the installation
for all the Power Modules.
The Foot Crank raises the lift tray faster than
the Hand Crank. Use this to raise the Power
Module to just below the tray assembly in
the drive. Use the Hand Crank for final
precise positioning.
Lift tray
Release
pressure in
cylinder
Seal
pressure in
cylinder
The Power Module should be handled carefully. After removing the packaging,
inspect the Power Module to confirm there is no damage and moisture.
To Next Page
Loading...
