Allen-Bradley Rockwell Automation 1734-4IOL - Quick Start - Prepare the Module to Work on Ethernet;Ip

Rockwell Automation Publication 1734-UM020B-EN-E - August 2019 11
Introduction Chapter 1
You can also issue a wakeup command to the target device using a CIP™ message
instruction.
See Chapter 4,
Configure IO-Link Device Parameters Using Message
Instructions.
Quick Start - Prepare the
Module to Work on
EtherNet/IP
ATTENTION: When devices wake up from fallback to IO-link
mode, response time for the devices may be impacted. Take
necessary precautions to avoid unintended operation of machines
or processes.
Mount the Module
See Chapter 2
.
Wire the Module
See Chapter 2
.
Add the POINT I/O 4 Channel IO-Link
Master Module on an Ethernet
Network
See Chapter 3
.
Configure the POINT I/O 4
Channel IO-Link Master Module
as IO-Link Master Using
Studio 5000 Add-on Profile
See Chapter 4
.
Configure the POINT I/O 4
Channel IO-Link Master Module
as Standard Digital Input or
Output Using Studio 5000
Add-on Profile
See Chapter 5
.