Allen-Bradley Rockwell Automation 1734-4IOL - Chapter 5 Configure the POINT I;O 4 Channel 10-Link Master Module as Standard Digital Input or Output Using the Studio 5000 Add-on Profile; Configure the Module as Standard Digital Input Using the Configuration Tab

Rockwell Automation Publication 1734-UM020B-EN-E - August 2019 51
Chapter 5
Configure the POINT I/O 4 Channel IO-Link
Master Module as Standard Digital Input or
Output Using the Studio 5000 Add-on Profile
About This Chapter
In this chapter, you will learn how to do the following:
• Configure the Module as Standard Digital Input Using the
Configuration Tab
• Configure the Module as Standard Digital Output Using the
Fault/Program Action Tab
Configure the Module as
Standard Digital Input
Using the Configuration Tab
The following diagram shows the Configuration tab of a POINT I/O 4 Channel
IO-Link Master module in Studio 5000 using the Add-on Profile.
Each channel of your POINT I/O 4 Channel IO-Link Master module that is set
to standard digital input or fallback mode can be configured with individual
input filter times. The following table describes each parameter on the
Configuration tab.