Allen-Bradley Rockwell Automation 1734-4IOL - Add an IO-Link Device

34 Rockwell Automation Publication 1734-UM020B-EN-E - August 2019
Chapter 4 Configure the POINT I/O 4 Channel IO-Link Master as IO-Link Master Using the Studio 5000 Add-on Profile
3. Click Register IODD. The following dialog box appears.
4. Locate the IODD XML file, and then click Open.
This returns you to the previous dialog box that shows the tree list view of
registered IODD files.
5. Click Exit.
Add an IO-Link Device
After you register an IODD file, you can add an IO-Link device to an IO-Link
channel. This configuration can only be done while the project is offline.
1. In the channel tree, right-click on the IO-Link channel, and then select
Change.
Alternatively, you can click the Change button on the working pane.
The following dialog box appears.