3
Click one from [Preset 1] to [Preset 6), and then click
[OK].
The data
is
stored
in
the preset number.
• The function is operable when Defeat
is
set to
OFF.
•
Measurement values will not be lost in the event the system is reset
or
battery power is disconnected.
Recalling
a
Stored
Setting
(Preset
Call)
The preset memory stores various setting/adjustment information. T
hu
s,
it takes some time to call data from the preset memory.
1
Click [Call] for
"Preset"
in
the main menu.
Preset
Call
Store
,
2 Click one from [Preset
1]
to [Preset
6],
and then click
[OK].
The values of the selected preset number are retrieved.
• The function is operable when Defeat is set to
OFF.
•
If
the speaker system in the preset and the current speaker system do
not match, the preset cannot be retrieved.
•
If
the
AUX
input system in the preset and the current AUX input
system do not match, the items concerning the
AUX
input system are
unavailable
for
retrieval.
Setting
the
Speaker
System
(Output
System
Select)
U
nl
ess you select the output system, you cannot set any features. Be
sure to set the system first.
If
the selected system and the actual speaker
connections do not match, the speakers may be damaged. Make sure to
check the specifications
of
the speakers before selecting the system.
Only for the initial startup:
1
Click
[OK]
when a message appears.
The
Ou
tput
Sy
stem Select screen
is
displayed. Go to
Step
2.
From
a
PC
1
Click
[Output System) for [Shortcut) tab
in
the main
menu.
The
Output
System Select screen
is
displayed.
•
When you click
[110
Configuration] on the Function switching tab
and then [Output System Select], the
Output
System Select screen
will also be displayed. Refer
to
"Operating
the Function Switching
Tab"
(page
7).
2
Select
and click the speaker system, and then click
[NEXT].
System 1
(4
.2ch): Front 2way+Rear+SubW
System 2
(2
.2ch): Front 3way+SubW
System 3 (4.0ch): Front 3way+Rear
System 4
(5.1
ch): Front 2way+Rear+Center+SubW
•
Refer
to
Table I (Output System) in
"System Configuration"
(page
60).
Click [OK] when a confirmation message appears.
The Speaker Setup screen will be automatically displayed.
•
If no changes are made to current system settings, the operation will
close without displaying the confirmation screen.
3
Click [Full Range],
[
ON
]
or
[OFF],
etc., to set the
speakers.
Front High*
1
:
Full Range(Tweeter/OFF
Front Mid: Full Range
Front Low: Full Range/OFF
Rear: Full Range/OFF
Center: Full Range/OFF
Subwoofer ( 1,
2)
:
ON/OFF
Subwoofer Output: Stereo/Mono *
2
*
1
When you modify the
"Front High "
speaker setting to [Full Range],
a message to confirm the change will be display
ed
.
To
set
up
at
"Full
Range
,"
select
[YES]
and click
[OK]. Make sure the speaker being
used
for
this output is able
to
handle a full range source. Many
tweeters can be damaged when driven
by
a full range signal.
~
Only
when two subwoofers are connected,
is
this item able to be set.
Stereo: Subwoofer stereo (L/R) output
Mono: Subwoofer monaural output
13-
EN
To Next Page
Loading...
