5 Click [Setup] for "RoadEQ."
ALPINE PXA-H800 S()Uild
Manager
-X
6 When a confirmation message is displayed, check
the content and click [OK].
7 Click
[STARn
in the measurement start screen.
Countdown will start.
During the 10 second countdown,
go
outside the vehicle
and close
th
e door.
A test signal will be output from the speakers to measure the
acoustic characteristics of the cabin.
Do
not open any
doors until the finish message appears on the screen. If
external noise interferes with the measurement. If the error
screen is displayed, perform the measurement again.
•
If
you want to stop measurement, click [CANCEL].
•
If
no microphone is connected, a confirmation message will
be
displayed and measurement will not be carried out. Click {OK] to
cancel the indication.
8 When a confirmation message for closing the screen
is displayed, click [OK].
•
To
enable this function, Defeat should be is set to
ON.
• Measurement
of
RoadEQ takes approximately 7 minutes.
• Measurement values will not be lost in the eve
nt
the system is reset
or
battery power
is
disconnected.
rom
a
When
automatic measurement
is
completed, RoadEQ can
be
turned on
or
off
and its level can
be
selected.
1 Click [RoadEQ] for [Shortcut] tab in the main menu.
The Automatic Measurement tab screen will be displayed.
• When
you
click [Automatic Measurement] in the Function switching
tab, the Automatic Measurement tab screen will also be displayed.
Refer to "Operating the Function Switching Tab" (page 7).
2 Click [ON] or [OFF] for "RoadEQ."
When you click [ON], select the level.
• When you do not use RoadEQ, select {OFF].
3 Click
[T]
and select and click either [Level1 ], [Level
2], or [Level
3].
ALPINE PXA-H800
S()llllll
Manager
Level 1: Low correction level. Suitable for quiet vehicl
es.
Level
2:
Moderate correction level.
Level
3:
High correction level. Suitable for high speed
driving.
•
If
measurement is
not
completed,
or
a microphone is not connected,
this setting cannot be performed.
• When you change the speaker setting
of
On/Off, RoadEQ
automatically becomes
off
When you have changed the speaker
settings,
st
art the measurement step over again.
• After the setting, it is recommended to store the setting conte
nt
s 011
the unit. For details, refer to "Storing the Preset Values (Preset
Store)" (page 12).
21-EN
To Next Page
Loading...
