From
a
PC
5 Click a frequency and drag up or down to adjust the
level.
Frequency:
Front/Rear/Center:
20Hz-20kHz
(1/3 octave step)
(1
to
31
Band)
SubW: 20Hz to 160Hz (1/3 octave step)
(1
to
10
Band)
Level: -12
to
+12dB (in 0.5dB step)*
* When lmprintEQ
is
enabled, -6
to
+6 dB (in 0.5 dB steps)
• Mouse trace function
When you click [Mouse Trace
OFF], the mouse trace function
becomes enabled, and [Mouse Trace
OFF] changes
to
[Mouse Trace
ON]. When dragged, the cur
ve
(settings) changes in accordance with
the movement
of
the cursor.
To
disable the mouse trace function, click the [Mouse Trace ON].
•
You
can also make adjustments by operating the settings indication
area (Frequency, Level).
The current setup value will be displayed
at
the bottom
of
the Screen.
Click
[
'1/ff
] and select and click a setup value.
You
can also use the
[Tab], [
f-
], [
---?},
[ j
},
and [
j.
] keys on your PC
to
select the
setup value.
Band
Frequency level Q Factor
l
ch
8:>rd1~
41100Hz
,.
•ltll
d8
,.
t:Q
Band
Frequency
Level
0
Factor
R ch. B
::~nd1
4
4rt1J
u
H;:
+!
11
0
d8
& 0
6
To
adjust another channel, repeat Steps 4 through 5.
•
You
can listen with Defeat OFF (adjusted setup values)
or
with
Defeat
ON
(Initial value)
to
compare, by clicking either [ON]
or
[OFF]
of
"Defeat" in the main menu while in the adjustment mode.
• By clicking either
!
Ill
or
fil
l
of
"Mute" while in the adjustment
mode, you can mute the selected channel.
7 When setting is complete, click [Close Window].
•
To
enable this function, Defeat should be is set to
ON.
•
To
restore the channel which
is
currently being adjusted
to
the
default, click
[Ch. Flat].
To
restore all the channels to the initial
settings, click [All Reset].
Click [OK] when each confirmation
message appears.
• When the speaker is set
to
the
"OFF"
mode, the graphic equalizer
for
that speaker cannot be set. Refer to "Setting the Speaker System
(Output System Select)" (page
/3)/
"Setting the Speakers (Speaker
Setup)/Setting the
Subwoofers" (page 14).
• Check the playable frequency ranges
of
the connected speakers
before making equalizer adjustments.
If
the speaker's playable
frequency range
is
55 Hz
to
30kHz,
for
example, adjusting the
40Hz
or
20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
24-EN
• After the setting, it is recommended
to
store the setting contents on
the unit. For details, refer
to
"Storing the Preset Values (Preset
Store)" (page 12).
Displaying the data
1 Click [Show All Data].
The
setup values
for
all
the
channels
will
be displayed.
To Next Page
Loading...
