Alpine PXA-H800 - Page 73

4 Bend the bracket@ to follow the curvature of the
Commander unit holder® and the console or the
underside
of the dashboard.
Screw holes
/1
I !
Commander unit holder
0
• To bend the bracket@, it is recommended to use a vise or pliers .
•
Use the appropriate screw holes of the bracket according to the shape
of the vehicle installation position (i.e., console or dashboard).
5 Run the connector plug of the Commander cable
through the hole of the Commander unit holder@.
* With the plug claw facing up, run the plug though the hole
diagonally
(as shown below).
Commander unit holder
Connector plug
&cAUTION
Doing so forcibly may break the plug.
6-EN
6 Tightly fix the Commander unit to the Commander
unit holder® with the provided 2 binding screws (M3
x 6
mm)@ and apply Adhesive sheets (b) and (c) to
the predetermined unit holder mounting positions.
Commander
unit holder
Screw (M3 x 6 mm) (x2)
7 Install the Commander unit from step 6 above in the
installation position.
Console or Dashboard etc.
Commander
Unit