Altec LASSIE2 Plus - Network Interface; Factory Settings; How to Initialize the Settings to the Factory Settings

137
Chapter 3 Handling
3
Network Interface
The LAN interface information for this printer is as shown below.
The network setting can be checked by printing the status sheet. See "Status Sheet Printing (LAN
interface model only)" on page 161.
Factory settings
The factory settings for this printer are as follows:
*1:The factory settings differ depending on the model.
*2:Default value with "IP address setting mode" set to "Manual".
How to initialize the settings to the factory settings
Follow the steps below to initialize the LAN interface of this printer.
1
Make sure that the printer is turned off.
2
Turn the power on while pressing the STATUS SHEET button; then continue to
press the status sheet button for ten seconds or more. The settings for the
LAN interface can be changed to the factory settings.
Item Factory settings
IP address setting mode
*1
Manual / Auto
IP address 192.168.192.168
*2
Host computer name EPSONxxxxxx
(xxxxxx sets the lowest 6 digits of the MAC address.)
Domain name None
The printer driver has no function to automatically follow the IP address set for the printer. If the
printer is used with "IP address setting mode" set to "Auto", printing may be disabled. We
recommend consulting with the network administrator in advance or setting the fixed IP address
using any of various types of utilities (InstallNavi, EpsonNet Config, EPSON Deployment Tool,
etc.). See "Utilities and Manuals" on page 175.