Altec LASSIE2 Plus - When the Printer Is Not Found Even if Epsonnet Config Is Started

156
When the printer is not found even if EpsonNet Config is started
When the printer is not found even if EpsonNet Config is started, follow the steps below.
1
Restart EpsonNet Config.
Exit EpsonNet Config without pressing the [Refresh] button and then start it again.
2
Wait 30 seconds.
3
If the printer is not found after 30 seconds have passed, repeat Step 1 to 2.
If the problem is not solved even if the steps are repeated about 5 times, check the LAN cable
connections and whether the Link LED on the lower rear side of the printer is on.
See "Back" on page 15.