204
Die-cut label(Gap)
Media type Plain label / Matte label / Synthetic label / Glossy label
Media source Roll paper
Backing paper width 30 to 112 mm {1.18 to 4.41"}
Label width 25.4 to 108 mm {1 to 4.25"}
Label length 8 to 1,117.6 mm {0.32 to 44"}
Gap between labels 3 to 6 mm {0.12 to 0.24"}
Left and right outer edges 2 mm 0.5 mm {0.079 0.02"}
Label edge R 1.5 mm {0.059"} or less
Paper thickness Plain label / Matte label / Synthetic label:
0.129 to 0.195 mm {0.005 to 0.008"}
Glossy label:
0.184mm {0.007"}
Paper core Plan label / Synthetic label:
External diameter: 44.1 mm {1.74"} or more
Matte label / Glossy label:
External diameter: 56.8 mm {2.24"} or more
External diameter Maximum 101.6 mm {4"}
Winding direction Printing face must be facing outside.
Form of perforated line Plain media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut
Fine media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut
PET film : 0.6 mm uncut, 8.4 mm cut
Do not use the paper with a hole or cutout.
If the backing is synthetic media or film, it will be difficult to cut by hand even if there is a per-
foration, so do not use the perforation.
Label width
Edge cutoff
Edge cutoff
Backing paper width
Label length
Gap between
labels
Edge R
Backing paper
Label area
To Next Page
Loading...