Altec LASSIE2 Plus - Page 25

25
Chapter 1 Product Overview
1
The following table shows the conditions for permitted missing dots and auto cleaning for each
nozzle check mode.
•Anti-missing Dot Mode
The auto nozzle check is performed at each timing, and by performing the auto head cleaning
when necessary, missing dots are prevented.
•Anti-missing Read Mode
The auto nozzle check is performed at each timing, and by performing the auto head cleaning
when necessary, missing reads due to missing dots are prevented.
•Anti-missing Color Mode
The auto nozzle check is performed at each timing, and by performing the auto head cleaning
when necessary, missing colors due to missing dots are prevented.
Condition
Anti-missing
Dot Mode
Anti-missing
Read Mode
(Default)
Anti-missing
Color Mode
No Missing Dot
Detection
Mode
Permitted missing dots None
1 missing dot or
less
No 2 consecutive
missing dots and
less than 9 missing
dots
-
Auto cleaning conditions
1 missing dot or
more
2 missing dots or
more
3 or more
consecutive dots
or 10 or more
missing dots
-
 Because the nozzle check is performed periodically during continuous printing, printing may
be interrupted for approximately 8 seconds.
 If more than 1 missing dot is detected, the auto head cleaning is performed to resolve the
missing dot.
 Because the nozzle check is performed periodically during continuous printing, printing may
be interrupted for approximately 8 seconds.
 If more than 2 missing dot is detected, the auto head cleaning is performed to resolve the
missing dot.
 Because the nozzle check is performed periodically during continuous printing, printing may
be interrupted for approximately 8 seconds.
 If 3 or more consecutive missing dots or 10 missing dots or more are detected, the auto head
cleaning is performed to resolve the missing dots.