IS-300A
1. Special Precautions
1-3
!
Apply the specified supply voltage.
Application of a voltage outside the specified range may result in fire or
electric shock.
Do not allow water to come in contact with the equipment.
Water on the electric parts can cause electric shock and short circuit.
!
Use proper tools (wire strippers, pressure wire connectors, etc.) for
terminal treatment of the connecting cables.
Do not cut the wire conductor; fire or electric shock may result.
!
Install the equipment on a firm and level surface.
Injury may result if the equipment falls or is dropped.
Do not sit on or place objects on the Power Supply.
Failure to observe this precaution may lead to malfunction.
!
Keep combustible matter away from the Power Supply.
Surface flash and expulsion may ignite combustible matter. If it is
impossible to remove all combustible matter, cover it with non-combustible
material.
Do not cover the Power Supply with a blanket, cloth, etc.
Do not cover the Power Supply with a blanket, cloth, etc. while it is in use.
The cover may be overheated and burned.
Do not use this Power Supply for purposes other than welding.
Use of this Power Supply in a manner other than specified can cause
electric shock and fire.
!
Use ear protectors.
Loud noises can damage hearing.
!
Keep a fire extinguisher nearby.
Keep a fire extinguisher in the welding shop in case of fire.
!
Maintain and inspect the Power Supply periodically.
Maintain and inspect the Power Supply periodically, and repair any damage
nearby before starting operation.
CAUTION
!
To Next Page
Loading...
