IS-300A
4. How to Operate Screens
4-21
(8) COPY SETUP DATA Screen
The MA-660A can store data. (Refer to figure shown below.)
When the MA-660A is connected to the Power Supply, the data stored in the
Power Supply memory is displayed on the Monitor Panel.
When the data is changed and the ENTER key is pressed, the contents of the
memory of the Power Supply are overwritten by the new setting.
When two or more the Power Supply units are used and the contents of the
memory of the first unit need to be copied to the second unit, copy the data from
the first unit to the memory of MA-660A temporarily, then copy this data to the
second unit.
For how to perform a schedule copy, see the next page.
The schedule copy can be performed between IS-300As with the same program
version of MA-660A (IS-300A). The program version of MA-660A (IS-300A) is
displayed on the POWER SUPPLY STATE screen. (See (2)(g).)
CURSOR
ENTER
MENU
ON
OFFRESET
TROUBLE
Data are not stored
only be changing
data on screen.
Be sure to press the
ENTER key.
IS-300A stores data,
independently from MA-660A.
Memory
MA-660A stores data for
one IS-300A unit.
IS-300A memory
Screen
To Next Page
Loading...
