Amada IS-300A - (2) Precautions for Handling; (3) On Disposal

IS-300A
1. Special Precautions
1-4
(2) Precautions for Handling
 When transporting or moving the Power Supply, do not lay it down. Also, handle the
Power Supply with care so as not to make an impact such as drop on it.
 Install this Power Supply on a firm and level surface. If it is inclined, malfunction
may result. For ventilation, provide 10 cm clearances to the intake and exhaust (See
5.(1)).
 Do not install the Power Supply in the following locations:
 Damp areas (where the humidity is higher than 90%),
 areas where temperatures are above 40°C or below 5°C,
 areas near a high noise source,
 areas where chemicals are handled,
 areas where water may condense,
 dusty areas,
 areas exposed to large amounts of vibration or shock, and
 areas at an altitude above 1000 meters.
 Clean the exterior of the Power Supply using a soft, dry cloth or one slightly
dampened with water. If the Power Supply is very dirty, use diluted neutral detergent
or alcohol. Do not use paint thinner, benzine, etc., as they may discolor or deform
the Power Supply.
 Do not insert a screw, coin, etc. into the Power Supply, as they may cause
malfunction.
 Operate the Power Supply in accordance with the method described in this
operation manual.
 Press switches/buttons carefully by hand. Handling them roughly (using a
screwdriver or the tip of pen) may result in a malfunction or failure.
 Press switches/buttons one at a time. Pressing more than one switch/button at a
time may result in a malfunction or failure.
 The Power Supply is not equipped with auxiliary power such as an outlet for
lighting.
 Following cables are separately needed to use the Power Supply:
 Program box, and circuit cable connecting to the Power Supply,
 power cable, and cables connecting between the Power Supply and welding
transformer,
 welding transformer,
 welding head, and
 secondary conductor connecting between welding head and welding transformer.
 The RS-485/232C communication signal line is not attached. Solder the line to the
RS-485/232C connector.
 The I/O signal line to start the Power Supply is not attached. Prepare the crimp-on
terminal and line for wiring to the terminal strip.
 The Power Supply should be used with the industry power transmission and
distribution network (industrial distribution equipment). Do not connect it to the
public low-voltage distribution network (distribution equipment for non-industrial
office or home use).