Pantera 4502 CP1_E3A_E4 BAG0166.5
11.2 Preparing for spraying operation
• The field sprayer must be operating properly in order to guaran-
tee correct application of the crop protection agent. Have the
field sprayer tested regularly on a test rig. Rectify any deficien-
cies immediately.
• Make sure of using the correct filter equipment, see page 103
• Clean the field sprayer thoroughly before applying a different
crop protection agent.
• Flush the nozzle line before:
ο each time changing a nozzle.
ο before rotating the multiple-nozzle head to another nozzle.
See the section on "Cleaning", page 204
• Fill the flushing water tank and the fresh water tank.
11.3 Preparing the spray liquid
WARNING
Risk of accidental contact with crop protection agent and/or
spray liquid.
•
Always induct the crop protection agent into the spray liquid tank
using the induction bowl.
• Swivel the induction bowl into the filling position before pouring
in crop protection agent.
•
Observe the safety regulations on physical protective equipment
and breathing apparatus for use when handling crop protection
agent and preparing the spray liquid, in the instructions for use
of the crop protection agent.
• Do not prepare the spray liquid in the vicinity of wells or surface
water.
•
Avoid leaks and contamination with crop protection agent and/or
spray liquid through appropriate conduct and wearing appropri-
ate physical protection equipment.
• To avert risks to third parties, do not leave the prepared spray
liquid, unused crop protection agent or used crop protection
agent canisters and the uncleaned field sprayer unattended.
• Protect contaminated crop protection agent canisters and the
contaminated field sprayer from precipitation.
• During and after preparing the spray liquid, ensure sufficient
cleanliness in order that risks may be kept as low as possible
(e.g. thoroughly wash used gloves before removing them and
dispose of the washing water and cleaning fluid in the proper
manner).
To Next Page
Loading...
