Cleaning, maintenance and repair
BAG0166.5 12.18
13.9 Line filter
(Fig. 203/1) 3 - 4 months depending on op-
erating conditions).
• Change damaged filter inserts.
204
1. Press the locking piece together
on the two lugs.
2. Remove the locking piece with O-
ring seal, pressure spring and fil-
ter insert.
3. Clean (rinse out) the filter insert
with petrol or thinner and then
blow it dry with compressed air.
4. To reassemble, reverse the pro-
cedure and make sure that the O-
ring seal is not twisted in the
guide slot.
To Next Page
Loading...
