Construction and function of the field sprayer
Pantera 4502 CP1_E3A_E4 BAG0166.5
6 Construction and function of the field sprayer
6.1 Functionality of the field sprayer
The spraying pump (4) sucks in via the suction chest (14), suction line
(5) and suction filter (6).
• the spray liquid from the spray liquid tank (1).
• Flushing water from the flushing water tank (2).
The flushing water serves to clean the spray system.
• fresh water via the external suction port (3).
The liquid that has been drawn in is fed via the pressure hose (7) to
the pressure equipment switch tap (13), and from there is fed
• via the self cleaning pressure filter to the part width section
valves (8). The part width section valves then send the liquid to
separate spray lines.
The stirring level can be increased when stirring spray liquid by
using the additional agitator setting tap (15) on the pressure fil-
ter.
• to the injector and the induction bowl (9).
To prepare the spray liquid, pour the relevant quantity of agent
required to fill the spray liquid tank into the induction bowl and
evacuate into the spray liquid tank.
• directly into the spray liquid tank (18).
• to the internal (17) or external cleaning switch tap (16).
The agitator pump (10) supplies the main agitator (11) in the spray
liquid tank.
The automatic filling level dependent regulation (12) of the main agit
a-
tor ensures for a homogeneous spray liquid in the spray liquid tank
To Next Page