Amazone Pantera 4502 - Diesel Engine Oil Level Check and Oil Change

Cleaning, maintenance and repair
222
Pantera 4502 CP1_E3A_E4 BAG0166.5
12.18
13.6.7 Diesel engine oil level check and oil change
The oil level must be checked using the dipstick
every day. The dipstick is located on the right
side of the engine. We recommend that the oil
level is checked in the morning before the engine
has started.
1. The machine must be standing on a level
surface.
2. Pull out the dipstick (Fig. 162
/1) and clean it
using a clean cloth.
3. Insert the dipstick into the opening again
and pull it back out.
→ The correct oil level lies between the mark-
ings.
4. When required, the oil level must be
topped-up through the filling opening (Fig.
162/2,3) using the specified oil.
→ Clean the filling opening thoroughly first.
5. Check the oil level and then close the cov-
er.
Fig.
163
Never fill oil when the engine is
running!
Changing the oil
1. Run the engine warm.
2.
Park the vehicle horizontally. Lubricating oil temperature approx.
80° Celsius.
3. Turn off the engine.
4. Place an oil drip pan under the engine.
5. Unscrew the oil drain plug (Fig. 162/4).
6. Drain the oil and, where applicable, drain the oil cooler content.
7. Screw in the oil drain plug with a new seal and tighten.
8. Fill with lubrication oil.
ο Details for quality / viscosity, see Seite 217.
ο Initial filling quantity 26.5 litres.
ο The maximum marking on the dipstick is decisive for the
filling quantity.
9. Check the oil level.
CAUTION
Risk of scalding when draining due to hot oil!