General Safety Instructions
Pantera 4502 CP1_E3A_E4 BAG0166.5
2.16.3 Electrical system
• When working on the electrical system, always disconnect the
battery (negative terminal).
• Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – risk of fire.
• Risk of explosion. Avoid sparking and naked flames in the area
of the battery.
• Ensure that the battery is connected correctly - firstly connect
the positive terminal and then connect the negative terminal.
When disconnecting the battery, disconnect the negative termi-
nal first, followed by the positive terminal.
• Always place the appropriate cover over the positive battery
terminal. If there is accidental earth contact, there is a risk of ex-
plosion
• The machine may be equipped with electronic components
whose function is influenced by electromagnetic interference
from other units. Such interference can pose risks to people, if
the following safety information is not followed.
ο If retrofitting electrical units and/or components on the ma-
chine with a connection to the on-board power supply, the
user is responsible for checking whether the installation
might cause faults on the vehicle electronics or other com-
ponents.
ο Ensure that the retrofitted electrical and electronic compo-
nents comply with the EMC directive 2014/30/EU in the
appropriate version and bear the CE mark.
• The cable clips must be checked for tight fit on a regular basis.
Corrosion to cable connections will lead to the loss of tension.
Clean and grease with acid-free Vaseline.
• The battery acid is highly corrosive and any contact to skin
should therefore be avoided. If however, acid should get into
your eyes, immediately rinse under running water for 10 to 15
minutes and seek medical advice immediately.
• Replace damaged cables immediately.
• Old batteries must be disposed of according to regulations.
• Store the batteries in a dry area during the winter periods (corro-
sion).
To Next Page