Structure and function, carrier vehicle
BAG0166.5 12.18
Fuel quality
The following fuel specifications are approved:
• Diesel fuels
Sulphur ≤ 10 mg/kg
ο DIN 51628
ο EN 590
Sulphur ≤15 mg/kg
ο ASTM D 975 Grade 1-D S15 –
ο ASTM D 975 Grade 2-D S15
• Light fuel oil (EN 590 quality)
Sulphur ≤10 mg/kg
Take care that you fill the tank with the fuel for the respective season!
Additives are contained in winter fuel that prevent the formation of
paraffin and ice crystals at low temperatures. Otherwise this may lead
to blockages in the fuel system.
When using the machine in transitional periods, you should therefore
fill the tank with fuels complying with DIN/EN 590.
5.2 Exhaust gas treatment
Only for Euro 4 Emission Standard
The exhaust treatment consists of :
• Oxidation catalyser
• Particle filter with regeneration system
• Selective catalytic reduction (SCR) with DEF
5.2.1 Diesel particle filter
WARNING
Risk of burns from a hot particle filter.
During regeneration, the diesel particle filter on the machine can get
up to 500° hot. While the machine is running, always keep people
away from it.
The particle filter is continuously regenerated while the motor is run-
ning.
To Next Page