Cleaning, maintenance and repair
Pantera 4502 CP1_E3A_E4 BAG0166.5
Replacing the wheels with another offset depth
The offset depth influences the track width of the machine.
The wheels used must be entered for the correct display of the track
width on the AMADRIVE.
→ The minimum track width must be no less than 1800 mm. Oth-
erwise, the wheels will collide with the running gear and there is
a risk of tipping.
Tyre pressures
• The required tyre pressure is dependent on
ο tyre size.
ο tyre loading capacity.
ο speed.
• The operational performance of the tyres is reduced
ο by overloading.
ο if tyre pressure is too low.
ο if tyre pressure is too high.
• Check tyre pressures regularly when the tyres are cold, i.e. be-
fore starting a run (see page ).
• The difference in pressure between the tyres on one axle must
be no greater than 0.1 bar.
• Tyre pressure can be raised by up to 1 bar after a fast run or in
warm weather. Tyre pressure should on no account be reduced
as it is then too low when the tyres cool down.
Fitting tyres
• Remove any instances of corrosion from the wheel rim seating
surfaces before fitting a new / another tyre. Corrosion can cause
damage to the wheel rims when the vehicle is in operation.
•
When fitting new tyres, always use new valves for tubeless tyres
or new inner tubes.
• Always fit the valves with valve caps which have a gasket insert.
To Next Page