Pantera 4502 CP1_E3A_E4 BAG0166.5
Determining the nozzle type, nozzle size, spray pressure and individual nozzle output
1. Determine the working point for the required spray rate (200
l/ha) and the intended operational speed (8 km/h).
2. At the working point, trace a line down the table. Depending on
the position of the working point, this line will run through the
cells for various nozzle types.
3. Select the best nozzle type for the crop protection measure in
question, with reference to the required atomisation characteris-
tic (fine, medium or coarse-dropped).
→ Nozzle choice for the example given above:
→ Nozzle type: AI or ID
4. Go to the spray table (Fig. 208).
5. In the column with the intended operational speed (8 km/h), find
the required spray rate (200 l/ha
) or a figure which is as close as
possible to the required spray rate (in this case, for example,
195 l/ha).
6. In the line with the required spray rate (195 l/ha),
ο read the nozzle sizes in question. Select a suitable nozzle
size (e.g.'03').
ο where the nozzle size column intersects with the selected
nozzle size, read the required spray pressure (e.g. 3.7 bar).
ο read the required individual nozzle output (1.3 l/min) for
calibrating the field sprayer.
Required individual nozzle output for
calibrating the field sprayer:
1.3 l/min
To Next Page