Ametek UCS 200N .2 Series User Manual

AMETEK CTS UCS 200N
Manual for Operation V 2.41 13 / 54
4.2.
Service
SERVICE
F1 : Addresses
F2 : Selftest
F3 : Setup
F4 : Set default values
F1
F2
F3
F4
F5
F6
F7
F1 Addresses
The addresses of the AMETEK CTS GmbH and
AMETEK CTS Germany GmbH are shown.
The addresses of all AMETEK CTS sales agencies
are listed on the web site of EM Test under :
www.emtest.com
F2 Selftest
Together with the user the firmware can test some parts of the equipment. The software will clearly explain the
self-test procedure.
F3 Setup
The software will clearly explain the set-up procedure.
F4 Set default values
Set the following standard parameters to the factory settings:
ISO 7637-2-3:2004, Jaso D001, SAE J1455
4.3.
Setup
SETUP
F1 : Change language / Sprache ändern
F2 : LCD backlighting
F3 : Interfaces
F4 : Keyboard-Beeper
F5 : Power-on counter
F1
F2
F3
F4
F5
F6
F7
F1 Change language
The user can chose between two languages, German and English.
F2 LCD backlighting
With the use of F2 the backlighting can be switched On or Off. Additionally the Auto Off function can be
programmed to switch off the backlighting after a specified time the generator has not been in operation (1 -
30min).
F3 Interfaces
This menu will help the user to define the status of the integrated serial and parallel interfaces, e.g. the baud rate
of the RS 232 or the address of the IEEE interface.
F4 Keyboard-Beeper
F1 is the selector for the beeper ON/OFF mode.
The beeper is always on when a test routine is finished. To indicate that a running test is finished the beeper
sounds 3 times.
F5 Power-on counter
Pressing of F5 will show the total power-on time and testing time of the test equipment.

Ametek UCS 200N .2 Series Specifications

General

Brand	Ametek
Model	UCS 200N .2 Series
Category	Test Equipment
Language	English