60 ASC110/ASC130/ASC150/ASC200/ASC250
2.6. Controls and control devices
Travel control (1)
Use this control to adjust the travel direction
and speed. The travel speed depends on
degree of the control movement from the ne-
utral position. At the same time, it is only used
as a operating brake of the machine. The
control is locked in the set position. Signal
lamp (24) will light up to indicate neutral position of the
control (N). Vibration switch (6) is located in the control
grip.
! NOTE !
The engine can only be started when in neutral.
Vibration cannot be activated in neutral (vibrator
bearings are not lubricated during vibration on the
spot).
To Next Page
Loading...
