AMX NXD-700i - Ice; ICM-Talk; ICM-Listen; ICM-Miclevel

Programming
119
NXD-700i & NXT-CA7 7” Modero Touch Panels
Intercom Commands (Cont.)
^ICE' Intercom end - this command terminates an intercom call/connection.
Syntax:
SEND_COMMAND <DEV>,"'^ICE'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICE'"
SEND_COMMAND TP2,"'^ICE'"
Terminates an intercom call between two panels.
^ICM-TALK See ^ICM section on page 118.
Syntax:
SEND_COMMAND <DEV>,"'^ICM-TALK'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICM-TALK'"
^ICM-LISTEN See ^ICM section on page 118.
Syntax:
SEND_COMMAND <DEV>,"'^ICM-LISTEN'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICM-LISTEN'"
^ICM-MICLEVEL Set the microphone level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MICLEVEL"
Variables:
MICLEVEL: Range = 0 - 100
Example:
SEND_COMMAND TP1, "^ICM-MICLEVEL,40"
^ICM-MUTEMIC Set the state of the microphone on a panel to muted (1) or un muted (0).
At the start of each call the microphone starts out un muted.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MUTEMIC"
Variables:
None.
Example:
SEND_COMMAND TP1, "^ICM-MUTEMIC,1"
^ICM-SPEAKERLEVEL Set the speaker level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-SPEAKERLEVEL,55"
Variables:
Valid levels are from 0 to 100.
Example:
SEND_COMMAND TP1, "^ICM-SPEAKERLEVEL,55"