AMX NXD-700i - ?Phn-Autoanswer; Phn-Answer; Phn-Autoanswer; Phn-Call

Programming
123
NXD-700i & NXT-CA7 7” Modero Touch Panels
The following table lists and describes SIP commands that are sent to the touch panel to manage calls.
SIP Commands
^PHN-ANSWER Answers the call.
Syntax:
"'^PHN-ANSWER, <connection id>'"
Variable:
connection id = The identifying number of the connection
Example:
SEND_COMMAND Panel,"'^PHN-ANSWER, 1'"
^PHN-AUTOANSWER Enables (1) or disables (0) the auto-answer feature on the phone.
Syntax:
"’^PHN-AUTOANSWER, <state>’"
Variable:
state = 0 (Disable) or 1 (Enable)
Example:
SEND_COMMAND Panel,"'^PHN-AUTOANSWER, 1'"
Enables the auto-answer feature.
?PHN-AUTOANSWER Queries the state of the auto-answer feature.
The panel responds with the ^PHN-AUTOANSWER, <state> message.
Syntax:
"’?PHN-AUTOANSWER’"
Example:
SEND_COMMAND Panel,"'?PHN-AUTOANSWER'"
^PHN-CALL Calls the provided number.
Syntax:
"’^PHN-CALL, <number>’"
Variable:
number = The provided phone number
Example:
SEND_COMMAND Panel,"'^PHN-CALL, 2125551000'"
^PHN-DTMF Sends DTMF codes.
Syntax:
"’^PHN-DTMF, <DTMF code>’"
Variable:
DTMF code = 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, POUND, or ASTERISK.
Example:
SEND_COMMAND Panel,"'^PHN-DTMF, 1234567879ASTERISK'"
^PHN-HANGUP Hangs up the call.
Syntax:
"’^PHN-HANGUP, <connection id>’"
Variable:
connection id = The identifying number of the connection
Example:
SEND_COMMAND Panel,"'^PHN-HANGUP, 1'"
^PHN-HOLD Places the call on hold.
Syntax:
"’^PHN-HOLD, <connection id>’"
Variable:
connection id = The identifying number of the connection
Example:
SEND_COMMAND Panel,"'^PHN-HOLD, 1'"