v.early.1.03 – published on December 20, 2021
33
Obstacle avoidance
To calibrate the obstacle avoidance system, set up your full ecosystem for a
flight: obstacle avoidance calibration implies a short flight in a straight upward
line, and a full rotation of the drone (360°).
Obstacle detection calibration interface
Therefore, it must always be carried out in the open, ideally in a zone fully
authorized to drone flights:
- use the Quick calibration (50 meters) option in zones where ANAFI Ai
may not be flown over that height - 50 meters calibration is slightly
downgraded and it should only be used in flattest environments;
- the Optimal calibration (120 meters) option provides the best quality
calibration, and must be favored whenever possible.
Tap an option to select it: ANAFI Ai takes off, reaches the selected height,
performs a 360 (full rotation) and descends.
Calibration in progress
To Next Page
Loading...