ANAFI Ai - Vehicle

ANAFI Ai
86
Tap the green arrow on the right of the left bottom bar of the Flight Plan
interface to begin the Flight Plan: ANAFI Ai takes off, flies to the first waypoint
and starts the Flight Plan. At the end of the Flight Plan, depending on your
settings and depending on your version of FreeFlight 7, ANAFI Ai lands at, or
hovers over, the last waypoint you have set.
That is why, for this section, we have chosen to consider that ANAFI Ai’s final
waypoint is also its landing spot.
Activate and monitor every Flight Plan with extreme care: always check your
drone’s route is clear from obstacles and safe, always retain visual contact
with ANAFI Ai, and always be ready to stop the Flight Plan (tap the “STOP”
box of your HUD or reclaim commands of the drone) in case a danger or any
sort of unexpected obstacle arises.
Vehicle
The Vehicle mission enables authorized pilots to take off and control their drone from a
moving vehicle (for example a platform-van or a boat), then to land it back safely on the
moving vehicle.
This feature requires a double GPS fix (drone and device) to be activated.
From take-off, ANAFI Ai synchronizes its speed and trajectory to that of the vehicle,
following it. The pilot retains control of the flight of the drone, relative to the vehicle’s
reference.
In other words, the drone follows the vehicle by default, when no control command is
activated. However, the pilot keeps control of the precise trajectory of ANAFI Ai, of its
direction, and thus of the framing of the camera.
During a Vehicle mission, activating the RTH command initiates a return sequence toward
the vehicle (RTV: Return To Vehicle). This sequence can be ended either by an automatic
landing, or by a synchronized hovering above the vehicle.
Additional details to come (maximum speeds, full procedure).