ANAFI Ai - Taking Photos

ANAFI Ai
60
Taking photos
To access the photo options of ANAFI Ai tap the “Mode” box in the bottom bar of the
HUD.
Six photo modes are available on ANAFI Ai: Photo (single shot), Timelapse,
GPS Lapse, Panorama (4 formats), Bracketing and Burst.
Thanks to its 48MP CMOS sensor, ANAFI Ai produces three main picture formats:
- rectilinear (48MP or 12 MP) JPEG;
- wide 48MP or 12 MP JPEG and DNG (Digital NeGative: Adobe open
standard RAW format);
- composite panoramas (JPEG), up to 32MP.
Note that the HDR option is only available for 12MP JPEG photos.
First, select a photo mode by tapping the “Mode” box of the HUD.
The options appear on your device. Tap a photo mode to select it.
When a photo mode is selected, the soft shutter button of the HUD appears as a full
white circle.
There is no option for the “Photo” (single shot) and “Burst” modes.
Selecting the “Timelapse” mode opens seven options: 0.5 sec (12MP only), 1 sec,
2 secs, 4 secs, 10 secs, 30 secs and 60 secs.
Selecting the “GPS Lapse” opens six options: 5m, 10m, 20m, 50m, 100m, and 200m.
Selecting the “Panorama” mode opens four options: Vertical, Horizontal, 360 and
Super Wide.
The Panorama mode is the only photography mode which requires the drone
to be flying before you can activate the shutter. Refer to the next section,
“ Generating Panoramas ”, for additional details about the “Panorama” mode.
Selecting the “Bracketing” mode opens three options: 3 photos (-1 EV, +0.0 EV,
+1 EV), 5 photos (-2 EV to +2 EV) and 7 photos (-3 EV to +3 EV). When one of these
options has been selected, the soft shutter button of the HUD displays the number
of the corresponding option.
Second, select a photo format from the corresponding box of the HUD.
Tap the “Imaging box” to call the photo settings boxes.
Tap the “Resolution box” to select 48MP or 12MP.
Tap the last box on the right of the screen to access the photo formats.