ANAFI Ai - Getting Started

ANAFI Ai
36
GETTING STARTED
1. Charge the battery using one of the enclosed USB-C to USB-C cables and the
enclosed charger. Refer to the “Battery charging” section of this guide for
additional information. Parrot recommends you always run a full charge of
your smart battery before flying ANAFI Ai.
2. Charge your Parrot Skycontroller 4.
3. Check that your flying zone is safe and clear.
4. To start the drone, place it on a flat horizontal surface and press the power
button until the drone’s fan starts turning (approximately 3 seconds).
5. Press the Skycontroller 4’s power button for 3 seconds, wait for the steady
dark blue light, then plug your device to the controller using a USB-C to Lightning
cable. Parrot recommends you always fly ANAFI Ai with Parrot
Skycontroller 4 and a device, for the best flight experience.
6. FreeFlight 7 runs automatically on your device and connects to ANAFI Ai and
to Parrot Skycontroller 4.
7. Check for controller and drone software updates.
8. Calibrate your ANAFI Ai, your Parrot Skycontroller 4, or both, if required,
following the instructions on the screen of your device.
9. Check that your flying zone is still safe and clear, and that no one (people, animal)
has approached or is approaching ANAFI Ai.
10. Stay at least 2 m (6 ft) clear from the drone, press the button and enjoy the
flight.