ANAFI Ai
4
PREREQUISITES
You want to put ANAFI Ai to work as soon as possible, so do we. Refer to the
enclosed Super Quick Start Guide (SQSG) if you need illustrated guidance to get
these quick prerequisites out of the way.
1. Wake up the batteries of your ANAFI Ai and Skycontroller 4. Charge the
batteries using the enclosed USB-C to USB-C cables. The batteries’ LEDs start
flashing: they are awake. Let them charge while you read. Parrot recommends you
always run a full charge of the smart batteries of your drone and controller
before flying ANAFI Ai.
2. Flash the following QR code to download FreeFlight 7 on your iOS device:
ANAFI Ai requires FreeFlight 7 to fly. The app will enable you to update your
Parrot Skycontroller 4 and ANAFI Ai when you power them on for the first time.
When you have downloaded and installed FreeFlight 7, press the power button of
the Parrot Skycontroller 4 and hold it for approximately 3 seconds (until its main
LED turns on in light blue) to power it on.
Press the power button of ANAFI Ai and hold it for approximately 3 seconds (until
the drone’s fan starts turning) to power it on.
Use the enclosed USB-C to Lightning cable to connect your device to the side USB-
C port of the Parrot Skycontroller 4, and install it as shown in the enclosed SQSG.
A prompt appears on your screen, which invites you to allow the communication
between your device and the controller.
3. Tap “Allow”: FreeFlight 7 runs.
To Next Page
Loading...