7. Testing
The analyzer can be set up to be as simple or sophisticated as you prefer. You
may simply insert a dipped urinalysis strip into the analyzer and the result will
be reported. By modifying the user options the measurements can be started,
printed and transferred automatically.
Alternatively, you have the option to enter the Sample ID, Patient ID, and color,
clarity of the specimen manually (See
7.2 Test features and customization).
The walkthrough for full testing is found in
7.3 Full Test.
The analyzer can be operated in two different modes:
1. In normal mode, the system automatically waits for the strip to incubate for 1
minute before it reads the first test pad. This is the default and recommended
mode and the throughput in this mode is approximately 50 strips per hour.
2. In fast mode, which can be selected at User Options, the test strip is meas-
ured directly after starting the test. In this case, it is up to the user to time
the incubation period outside the analyzer (see
7.2.1 Features: Autostart-,
print-, transfer- and fast mode).
If you require more information regarding use and storage of test strips, please
refer to the strip’s instructions of use.
7.1 Quick Test
After switching on the instrument starts with the Measurement screen.
The Measurement screen can also be directly reached from the Main and
Database screens
The test strip tray has to be correctly loaded into the reader. Have the test strip,
urine sample and paper towel ready too.
Dip the reagent strip into the urine sample, wetting all pads. Immediately re-
move the strip from the urine.
Drag the edge of the strip against the side of the sample container as you
remove it.
Blot by touching the edge of the strip to the paper towel to remove excess urine.
To Next Page
Loading...
