ID C. T. Text Long text Action
W56
W S Output
connect
Output port cannot connect
to server. Please check
ethernet cable, ethernet
configuration in settings
and server IP address and
port number.
The system continuously tries
to deliver the output. In case
of success, the error will auto-
matically disappear.
If the error persists, please
verify the connections and the
presence/status of the desti-
nation
W38
W S Head
version
Measure head SW version
is unknown. Please call
Service.
Contact your service repre-
sentative
W37
W S Tempera-
ture
Temperature out of allowed
range.
Ensure the proper environ-
mental conditions.
W35
W S Data lost
(limit)
Database limit exceeded.
Earlier results will be
dropped.
Free up memory by erasing
old data (circular memory op-
tion is enabled, so old data will
be overwritten by new data).
W34
W S Memory
near full
Database counter is reach-
ing its limit. Please delete
some results.
Free up memory by erasing
old data!
W33
W S QC lock-
out
Go to „QC measurement”
to perform QC check.
Perform QC check measure-
ments to remove the QC
lockout.
W32
W S Stri-
pholder
Stripholder error.
Can’t go to home position.
Please check it!
Check if the test strip tray is
placed properly in the housing
or remove any obstacles from
the path (4.2.2).
W31
W S Door
open
Printer door is open.
Please close it!
Check if the paper roll is cor-
rectly loaded in the printer bay
and close the printer door.
W30
W S Paper
out
Paper out.
Please replace the printer
paper!
Open printer door and load a
fresh paper roll in the printer.
E199
E P DB failure: cannot write
result. Please call Service!
Contact your service repre-
sentative.
EitherseePage61for‘full
database clear’.
E198
E P DB failure: cannot modify
result. Please call Service!
Contact your service repre-
sentative.
EitherseePage61for‘full
database clear’.
E197
E P DB failure: cannot delete
result. Please call Service!
Contact your service repre-
sentative.
EitherseePage61for‘full
database clear’.
To Next Page
