Andover Controls LCX 890 Series User Manual

LCX 890 Installation Guide 1
Setting Up an LCX 890 Series
Controller and Infinet
The LCX 890 family of controllers are lighting controllers, designed to
connect to lights and switches that control those lights. You can have up
to 24 relays for controlling lights, with or without the status feedback op-
tion on an LCX 890 and up to 48 relays on an LCX 898. Each output can
have a momentary switch, such as a motion sensor or other occupancy
sensor, that sends a command to the light.
You may also connect an EMX 170 or SP 100 SmartSensor module to
any LCX 890 series controller.
This manual covers the following:
• Site/System Setup Requirements
• Installing the LCX 890 or 898
• Powering Up the LCX 890 or 898
Warranty Registration
Your warranty is effective for 18 months starting on the date the system
is shipped.
Warning
All wiring and installations must comply with local, state, and national
electrical codes.

Andover Controls LCX 890 Series Specifications

General

Brand	Andover Controls
Model	LCX 890 Series
Category	Controller
Language	English