Andover Controls LCX 890 Series User Manual

52 LCX 890 Installation Guide
Figure 28. Wiring Diagram for Occupancy Sensor
Controlling ON/OFF and HI/LO Outputs
Setting the Lighting from Hardware
Rather Than Software
You either allow the programs to control the lighting or you can allow
a momentary switch (motion sensor, push button, or similar device) to
control it. You may have both, so that the software may set the lighting,
or the momentary switch may set it. You may set the lights manually
through the momentary switch, if you choose. But the software can
change the hardware setting at any time.
BLK YELRED WHT
(ON) (OFF)
BLK YELRED WHT
BLUE (+24 VAC Rect.)
ON
OFF
HI
LO
(ON) (OFF)
Controls 1st Output
Controls 2nd Output
. . .
Fluorescent
Tubes
. . .
Fluorescent
Tubes
V
1st Output
2nd Output
# 20/6
1000ft Maximum
ROSWIRE-6
ROSWIRE-6P
(Refer to earlier illustration
for location on controller.)

Andover Controls LCX 890 Series Specifications

General

Brand	Andover Controls
Model	LCX 890 Series
Category	Controller
Language	English