20 LCX 890 Installation Guide
Finding the Connection Ports on the LCX 898
Figure 4 shows the inside of the LCX 898 cabinet. This unit has two
dividers that extend from the top of the cabinet to the bottom.
In the center of the unit, between the two dividers, are two distinct
parts—the upper part, where the terminal wiring board is exposed, and
the lower part, where electronic components are covered by a metal
plate. Most of the connections are on the lower part where the compo-
nents are covered by the metal plate:
• Infinet connection, on lower left side.
• Service Port, to the immediate right of the Infinet connection.
•Port for EMX 170 or SP 100 module, in the approximate center.
To the far left and far right are a series of relays lined up in two rows
along each divider. In the lower right corner, to the far right is a small
printed circuit board near the bottom of the cabinet. On that printed cir-
cuit board are two more significant connections:
• AC Power Connection, in the far right lower corner of the controller.
• Voltage Selection Jumpers, just below the AC power connection.
To Next Page
Loading...
Need help?
General
