Andover Controls LCX 890 Series User Manual

28 LCX 890 Installation Guide
Locating the Inputs on an LCX 898
Find the inputs on the LCX 898 as follows:
1. Open the LCX 898 cabinet door.
Figure 9 shows the locations of the terminals for inputs, outputs, and
momentary switches on the LCX 898.
2. Notice the location of the first 16 inputs along the vertical center of
the upper part of the controller. They are labeled inputs 1 through 16
on the printed circuit board. You must always wire a switch to any
of these inputs.
3. The last eight inputs are along the bottom of the lower part of the
controller. They are labeled inputs 17 through 24 on the cover plate.
You can wire a thermistor, voltage, or current input to any of these
inputs.
Note also, that a wiring trough is provided near the top of the controller
cabinet. This comes in handy later, when you wire the inputs and
outputs.

Andover Controls LCX 890 Series Specifications

General

Brand	Andover Controls
Model	LCX 890 Series
Category	Controller
Language	English