18 LCX 890 Installation Guide
Finding the Connection Ports on the LCX 890
Figure 3 shows inside the LCX 890 cabinet. The LCX 890 has a vertical
metal divider about two-thirds across the cabinet that extends from the
top of the cabinet to the bottom.
On the left side of the divider are two distinct parts—the upper part,
where the terminal wiring board is exposed, and the lower part, where
electronic components are covered by a metal plate. Look on the lower
part, where the plate is located. You find the following connections:
• Infinet connection, on lower left side of lower part.
• Service Port, to the right of the Infinet connection, on lower part.
•Port for EMX 170 or SP 100 module, to the right of service port.
On the right side of the divider are two more distinct parts—the upper
part, a series of relays lined up in two rows along the divider, and the
lower part, a small printed circuit board near the bottom of the cabinet.
Look on the small printed circuit board near the bottom. You find the
following connections:
• AC Power Connection, to the right of the lower part of the
controller.
• Voltage Selection Jumpers, just below the AC power connection.
To Next Page
Need help?
General
