Anritsu Site Master S331L - System:mbtemperature; System:options; System:preset; [:Sense]:Base:brightness <Brightness-Level

Chapter 3 — All Mode Commands
S331L PM PN: 10580-00322 Rev. F 3-7
:SYSTem:MBTemperature?
Query Description: Query returns motherboard temperature in degree C.
Example: To query motherboard temperature:
:SYST:MBT?
:SYSTem:OPTions?
Query Description: Query returns option string delimited by "/".
Example: To query full option string:
:SYST:OPT?
:SYSTem:PRESet
Cmd Description: Presets the application to its default state. Use *OPC? to block till
preset is complete.
Example: To perform preset:
:SYST:PRES
[:SENSe]:BASe:BRIGhtness <brightness-level>
[:SENSe]:BASe:BRIGhtness?
Cmd Description: Command sets the brightness level.
Query Description: Query returns the brightness level.
Param Type: Integer
Param Range: 0 to 10 in increments of 1, where 0 is 0% and 10 is 100% brightness
setting.
Default Value: 10
Example: To set brightness to 5:
:BAS:BRIG 5
[:SENSe]:BASe:IPaddress?
Query Description: Query returns the IP address in a special format. Return value
example: 2887436918 (to recover the actual IP address of
172.26.202.118, you need to convert the returned value to hex
AC1ACA76 and then take the resulting 4 numbers (2 characters each,
in hex) and convert them back to decimal.
Example: To query IP address:
:BAS:IP?