Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-17
:CALCulate:TRANsform:DISTance:WINDow
RECTangular|MSLobe|NSLobe|LSLobe
:CALCulate:TRANsform:DISTance:WINDow?
Cmd Description: Command sets the window type for time domain.
Query Description: Query returns the window type for time domain.
Param Type: Character
Param Range: RECTangular|MSLobe|NSLobe|LSLobe
Default Value: NSLobe
Example: To set time domain window type to rectangular:
:CALC:TRAN:DIST:WIND RECT
:CAPTure:STARt
Cmd Description: Command starts the data capture for continuous sweeps. It does not
work in single sweep and hold mode.
Example: To start data capture
:CAPT:STAR
:CAPTure:STOP
Cmd Description: Command stops the data capture for continuous sweeps. It does not
work in single sweep and hold mode.
Example: To stop capture:
:CAPT:STOP
:CAPTure:TRACe#:DATA? FDATa|SDATa|FMEM|SMEM
Cmd Description: Command is used to return the data block of the specified trace at the
end of a sweep, while the instrument is in continuous sweep mode. This
command must follow the :CAPTure:STARt command. A
:CAPTure:STOP command is used to end the capture session. If the
system is in single sweep and hold mode, then this command is ignored.
Example: To trigger a sweep:
:CAPT:TRAC1:DATA? FDAT

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English