Chapter 3 — All Mode Commands
3-10 PN: 10580-00322 Rev. F S331L PM
[:SENSe]:BASe:TIME <time-in-seconds>
[:SENSe]:BASe:TIME?
Cmd Description: Command sets the time. Send a -1 to synchronize the system time with
GPS.
Query Description: Query returns value that represents the number of seconds from
1/1/1970.
Param Type: Integer
Param Description: Number of seconds from 1/1/1970
Default Units: s(seconds)
Example: To set the time to 3:09 on January 5, 2012:
:BAS:TIME 1325776177
[:SENSe]:BASe:VOLume <volume-level>
[:SENSe]:BASe:VOLume?
Cmd Description: Command sets the volume level.
Query Description: Query returns the volume level.
Param Type: Integer
Param Range: 0 to 10 in increments of 1, where 0 is 0% and 10 is 100% of volume
setting.
Default Value: 5
Example: To set volume to 7:
:BAS:VOL 7
[:SENSe]:BASe:VOLume:AUDio ON|OFF|1|0
Cmd Description: Command sets the audio state. ON means audio is enabled. OFF means
audio is disabled.
Param Type: Character|Integer
Param Range: ON|OFF|1|0
Default Value: ON|1
Example: To mute audio:
:BAS:VOL:AUD OFF
To Next Page
Loading...
Need help?
General
