Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-9
:CALCulate:LIMit:MESSage OFF|ON|0|1
:CALCulate:LIMit:MESSage?
Cmd Description: Command sets the limit message state. Displays a Pass/Fail message to
indicate whether the trace crosses the limit line.
Query Description: Query returns the limit message state.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set limit message on:
:CALC:LIM:MESS ON
:CALCulate:LIMit:MESSage:RESult?
Query Description: Query returns 0 if limit line says Fail. Otherwise, it returns 1 if limit
line says Pass.
Example: To get limit line Pass/Fail result:
:CALC:LIM:MESS:RES?
:CALCulate:LIMit:MODe
Cmd Description: Command changes the limit line to either Line or Segmented mode.
Example: To change the limit line mode
:CALC:LIM:MOD SEGM
:CALCulate:LIMit:PRESet
Cmd Description: Command presets the limit line to its default state.
Example: To perform limit line preset:
:CALC:LIM:PRES
:CALCulate:LIMit:TYPE 0|1
:CALCulate:LIMit:TYPE?
Cmd Description: Command sets the active limit line type. 0 for upper limit and 1 for
lower limit.
Query Description: Query returns the active limit line type.
Param Range: 0|1
Default Value: 0
Example: To set the active limit to lower limit:
:CALC:LIM:TYPE 1

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English